Publicidad
Idiomas disponibles
Idiomas disponibles
■ Do not dry clothes and other articles, do not cover them, stay away from inflammable and explosive articles when used.
Maintenance
■ Please cut off the power supply before maintenance
■ Check and clean the components frequently to avoid burning, smoking and danger.
■ If the surface is dirty, it can be wiped with a soft cloth stained with detergent. Chemical solvents such as gasoline and toluene are
not allowed. Do not wash in water.
■ If it is not used for a long time, clean it up first, then pack it into the packing box, store it in a flat and dry place, and do not apply
pressure on it.
Commissioning
■ Only connect the device to a properly installed safety socket
■ Make sure that the degree of protecLon of the socket to which the device is connected is of at least 10 ampere!
■ Place the device on a heat-resistant and level surface.
■ The distance from the air outlet grille to the nearest wall should be at least 1 m.
Assembly
CAUTION: If you would like to use the heater as a stand-alone device, itis essential to install the feet supplied.
Please note illustration 1, which shows the underside of the device.
Attach the two feet with the four screws. Use inly the supplied screws. Too long screws lead to damage.
Operation
1. Instructions for assembling the foot
2. The desired room temperature is set here.
The radiator offers 3 heating levels:
3.
750W
4.
1250W
3. & 4. 2000W
The control lamp lights up when the device is heating up.
Controlling Room Temperature
■ Turn the thermostat control knob to the highest level.
■ The LED will light up.
■ Once the desired room temperature is reached, turn the thermostat control knob slowly back until the device shuts off (control
lamp goes off).
■ The thermostat maintains the set room temperature by switching the device on and off.
Switching off
■ Turn the thermostat to ZERO (0) and slide the power switch to the off position to turn off the unit.
■ Remove the plug from the socket after use.
Functional characteristics
■ The device is equipped with an overheating protection that switches the device automatically off in case of overheating.
■ The product has the function of self-power-off protection when it falls or tilts.
■ The product has electronic room temperature control.
Overheating Protection
The device is equipped with an overheating protection that switches the device automatically off in case of overheating.
■ Shift the function switch to „0" position and pull out plug out of the socket. Let the device cool down for about 10 minutes before
using it again.
■ Check if the air inlet or outlet of the heater is blocked. If this is the case, the blockage should be removed.
■ Should the overheating protection shut the device off again shortly after, there is probably a defect. Switch off the device again and
pull out the plug.
Technical Information
Power Rating: 1800-2000W
Publicidad
