Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Start/ Stop
To start the pneumatic tool, press the trigger (picture 4), and keep it pressed during the job to be performed. Releasing the trigger will
cause the pneumatic tool to stop quickly.
Check the position of the
reversal
Direction of rotation setting
The pneumatic tool can rotate both clockwise and anticlockwise.
connected/disconnected
reversal
Disconnected pin 'F" FORWARD � clockwise - seen from the operator's side
Connected pin "R" REVERSE
Furthermore, rotating the reversal pin allows the following to be set (picture 4):
selection 1
minimum screwing torque (approximately 1/3 of nnax. torque)
selection 2
medium screwing torque (approximately 2/3 of max. torque)
selection 3
maximum screwing torque (max. torque)
Fit the required impact socket onta the male drive, and make sure that it is inserted correctly.
Always disconnect the air supply before fitting in tools or rnaking
accìdentally started.
LubricatiorvG reasing
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog
mixer,
set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
Il lubrication is not provided to the
(picture 6).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personn, e l. For such jobs, you can contaci Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty lor professional
use or a 24-month warranty lor nonprofessional use.
We will repair any breakdowns caused by materiai or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valici il any changes are made, or il the pneumatic tool is forced or seni to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby
declare,
assuming full
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-6
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITAL Y
Name and tille of person in charge
OBERTO CICERI
(P
esi
)
r �
(
� �. tn � ·
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
pin before operating the pneumatic tool, so as to know the direction of rotation.
pin (picture 3):
anticlockwise - see,n from the operator's side
'\..._j
line,
oil ISO 32 must be periodicallly poured into the pneumatic tool, through the air supply hole
□
ECLARATION oF coNFORMITY e E
responsibility,
that the described produci complies with all the relevant provisions of Machine
Sel
ect the direction of rotation by means of the
adj1ustrnents;
this precaution will prevent the pneurnatic tool from being
period,
the expiry date of this warranty will remain unchanged.
Date 21/12/2021
Publicidad
