Publicidad
Idiomas disponibles
Idiomas disponibles
6
Commissioning
6.1
Component Settings of the Remote Control Unit
6.1.1
General note on the hand-held transmitter
The hand-held transmitter displays every button command with
one of the LED indicators. Data processing between the
transmitter and the receiver takes about 1 second. The LED lights
longer for error messages and feedback signals.
The buttons must not be tapped too quickly in sequence
because they will otherwise not be processed.
LED 1 flashes red when transmitting if the battery capacity is
getting low.
6.1.2
Tuning the receiver to the transmitter
If the BADU JET Wireless Control II is supplied as a complete unit
(transmitter and receiver) or in connection with a BADU
countercurrent system, the transmitter and receiver are tuned to
each other. The remote control unit can be used as soon as the
system is installed.
In all other cases, the transmitter and receiver must be tuned.
The sequence for the "transmission channel pump" is shown here.
All other connections (buttons 1-9 of the transmitter to the 4 or 2
relays of the receiver) are made according to this example.
Sequence 4-channel receiver:
1.
Set the adjusting wheel to the left stop.
2.
Select the LED (K1) assigned to the appropriate relay with
button A.
3.
LED lights permanently.
4.
Press the assigned button on the remote control unit once.
5.
The receiver recognises the assignment and flashes a few
times.
Sequence 2-channel receiver:
1.
Select the LED assigned to the appropriate relay with button
3.
2.
LED lights permanently.
3.
Press the assigned button on the remote control unit once.
4.
The receiver recognises the assignment and flashes a few
times.
06|2020
Commissioning
EN 19
Publicidad
