Dip Switch Settings - Tripp-Lite N785-I01-SFP-D Guia De Inicio Rapido

DIP Switch Settings

DIP Switch Settings
Number Label
1 LLB
2 LFS
3 FX100
ALM (Alarm) DIP Switch Settings
4 PWR
5 RPS
6 LFS
Link Fault Signaling (LFS)
When the LFS DIP switch is enabled (#6), an alarm indicator will
illuminate to indicate when a cable has been severed or when some
other cause of disruption in service has occurred. The LFS function
monitors both copper and fiber segments for a total service report.
Line Loop Back Test (LLB)
Set DIP Switch 1 to "ON" to activate the LLB diagnostic test function. Use
the LLB function to check if the copper and fiber and fiber segments are
connected properly.
21-07-114 93-3F8C.indb 6 21-07-114 93-3F8C.indb 6
Description
ON: LLB is enabled
OFF: LLB is disabled
ON: LFS is enabled
OFF: LFS is disabled
ON: Port 2 (SFP) speed at 100 Mbps
OFF: Port 2 (SFP) speed at 1000 Mbps
ON: Master power alarm reporting is enabled
OFF: Master power alarm reporting is disabled
ON: Redundant power alarm reporting is enabled
OFF: Redundant power alarm reporting is disabled
ON: Alarm for LFS issue is triggered
OFF: Alarm LFS is disabled
6
6/8/2022 12:45:26 PM 6/8/2022 12:45:26 PM