Pedometer Configuration Walk And Run Stride Length Input - Bell TotalFit Manual De Instrucciones

All manuals and user guides at all-guides.com
PEDOMETER CONFIgURaTION - Walk aND RUN STRIDE lENgTh INPUT
Once all the units have been selected (See page 12), the computer, if it is in Pedometer mode, will
ask for the walk Wlk and run RUN stride length. This will allow the computer to accurately estimate
the Distance walked and run.
Once entered, the computer will NOT ask again for this information.
Note: To correct or modify the stride length at any time, press the UPPER RIGHT and BOTTOM button for
two seconds when the computer is in Pedometer Mode (See page 22).
hOW TO MEaSURE STRIDE lENgTh
Walk 10 steps forward in a straight line. Measure the distance walked in inches (or centimeters) from
the heel of the first step to the toe of the last step. Divide the distance walked by 10 and you will have
the average walking stride length. Process in the same manner for the average running stride.
Walk STRIDE INPUT (Wlk)
To enter the correct average walking stride, press the upper right button until the correct digit
furthest to the right appears. Press the upper left button to lock in the correct digit. Repeat until all
digits are entered.
RUN STRIDE INPUT (RUN)
After the Wlk stride length is selected, the RUN stride length screen will appear. Press the upper right
button until the correct digit furthest to the right appears. Press the upper left button to lock in the
correct digit. Repeat until all digits are entered.
14