Speedometer Installation Magnet And Sensor - Bell TotalFit Manual De Instrucciones

All manuals and user guides at all-guides.com
SPEEDOMETER INSTallaTION - MagNET aND SENSOR
Attach the speedometer sensor on the right fork of the front wheel using two of the cable ties provided.
Make sure the sensor is curved toward the wheel, and that the smooth side of the cable tie is facing
out. Do not fully secure the cable ties yet, as the sensor location might require some later adjustments
(Figure 2).
Clamp the round magnet on a spoke on the right side of the front wheel (Figure 1). Adjust the position
of the magnet so that when the wheel spins, the flat side of the magnet passes in front of the sensor
(Figure 2).
Adjust the sensor and magnet location so that clearance between magnet and sensor is not greater than
1/5" (5mm) (Figure 3). Once well positioned, secure the cable ties on the fork and tighten the magnet
screw on the spoke.
Note: Use caution when tightening the screw on the spoke as overtightening can strip the threads.
Figure 1 Figure 2 Figure 3
Magnet
Sensor
Bicycle fork
5mm
Magnet
(1/5")
Sensor
Top view
8