Publicidad
Idiomas disponibles
Idiomas disponibles
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.
PRIOR TO OPERATION
WARNING
To avoid serious accidents, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. Power switch
Ensure that the switch is in the OFF position.
3. Installing the sanding paper
CAUTION
○ Use only sanding paper size specifi ed on the
product nameplate.
○ Do not use accessories with poor adhesion.
Since the attachment is a hook-and-loop type, the
sanding paper can be installed easily by just pressing
it onto the pad.
(1) Gently pinch and hold together two places on the
edges of the sanding paper so that two holes are
visible on the bottom. (Fig. 7-a)
Fig. 7-a
(2) Overlap the two holes of the sanding paper with two
holes of the pad, and attach the whole surface of the
sanding paper to the pad so that the remaining holes
are also aligned. (Fig. 7-b)
Hold the sanding paper
so that two of its holes
are visible on the bottom
Sanding paper holes
Attach
Fig. 7-b
4. Attaching and Removing the Dust bag (Fig. 8)
(1) Attaching the Dust bag
Insert the dust bag into the duct on the body of the
power tool.
(2) Removing the Dust bag
Hold the duct, and pull out the dust bag.
Duct
Insert all the way
WARNING
Prior to the sanding operation, make sure the
material of surface you are going to sand.
If the surface under sanding operation is
expected to generate harmful / toxic dusts such
as lead painted surface, make sure the dust
bag or appropriate dust extraction system is
connected with dust outlet tightly.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts
generated in sanding operation, the dust can
endanger the health of yourself and bystanders.
English
Align the two
holes
Pad holes
Dust bag
Fig. 8
13
Publicidad
