Thread Tree; Using The Thread Spool Cap; Spool Mat; Using The Spool Mat - Brother 884-B30 Manual De Instrucciones

CHAPTER 2
PREPARATION BEFORE THREADING

Thread tree

Raise the telescoping thread tree to its highest
position. Make sure that the thread holders are
in alignment above the spool pins as illustrated
below.
Cover stitch model
2
Top cover stitch model
2
1 Thread holder on thread tree
2 Spool pin
3 Correct position
Using the thread
spool cap
When using sewing thread spools, the thread
spool cap should be used as illustrated below.
Make sure that the spool notch is on the bottom.
1 Thread spool cap
1
3
1
3
1
CAUTION
Before using a thread spool, be sure to remove the
spool cushion.
Before using loosely spun nylon thread, be sure to
install the spool cushion.
If the thread spool cap is not fully pushed down,
the thread may become entangled on the spool pin
or the needle may bend or break.

Spool mat

When using thread spools or loosely spun thread
that easily slips off the spool, place this mat under
the spool.
This prevents the thread from becoming entangled
on the spool pin.

Using the spool mat

1. Remove the spool cushion, and then place the
spool mat on the spool pin.
2. Place the thread spool (with the spool notch at
the bottom) on the spool pin, and then place the
thread spool cap on top and fully push it down.
1
1 Spool cushion
2 Thread spool cap
3 Spool support
4 Spool mat
CAUTION
If the thread spool cap is not fully pushed down
against the thread spool, the thread may become
entangled on the spool pin or the needle may bend
or break.
2
3
4
13