Descargar Imprimir esta página

Metabo HPT RH18DA Instrucciones De Seguridad Y Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Display
Temperature
display
Fig. 10-b
Temperature
86 – 752°F
set I
(30 – 400°C)
86 – 1,022°F
set II
(30 – 550°C)
NOTE
○ There may be a diff erence between the displayed
temperature and the actual temperature.
○ Press and hold the + and - temperature control buttons
at the same time to switch between Fahrenheit (°F)
and Celsius (°C).
2. About remaining battery indicator
The remaining battery level is also displayed on the
LCD <Display>.
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and battery
characteristics, read it as a reference.
16
Remaining
battery
indicator lamp
Temperature
control button
Table 5
Air volume
7.1 CFM
(200 L/min)
10.6 CFM
(300 L/min)
Table 6
Battery Remaining Power
Over 70%
55%–70%
35%–55%
20%–35%
Less than 20%
NOTE
○ When using a battery with a remaining battery
indicator, please refer to the indicator lamp on the
battery for the battery remaining power.
○ Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
3. How to use the LED light (Fig. 11)
The LED light will light the area at the tip of the tool
when the switch is on.
The LED light will automatically power off when the
switch is OFF.
LED light
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
4. Temperature Settings
WARNING
○ Do not use the tool in the vicinity of volatile
substances (thinner, gasoline, etc.)
○ Do not bring the nozzle in close contact with your
hands or face during use.
The nozzle is extremely hot immediately after
use, so do not touch it.
Set the temperature in consideration of the article to be
heated.
Also, pay attention to the surrounding material that will be
heated at the same time.
Switch
Fig. 11

Publicidad

loading