GET RX1 PRO Guia De Instalacion página 4

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Find the OEM ECU: check on
your motorbike's workshop manual
where to find it. Press the retainer
clip of the OEM ECU connector before
pulling it: make sure to remove the
connector without damaging it.
2.
Connect GET RX1 PRO ECU to
OEM connector. Make sure the
connector is properly plugged in, and
the retainer clip is fully engaged.
3.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
ATTENTION:
OEM handlebar commands to change maps and
launch control will not work after installing GET RX1
Pro ECU. To grant proper functionality and reliability
use only GET Map Switch (included in the kit) and
GET LC-GPA module (sold separately).
EN
4