GET RX1 PRO Guia De Instalacion página 6

If the engine does not start or does not work properly after this
procedure, e.g. for an incorrect installation of the ECU or an
inaccurate idle and TPS calibration:
1. Uninstall GET RX1 Pro ECU.
2. Install the OEM ECU back and resume the original engine
idle setting.
3. Start the bike and verify that the engine is working properly.
4. Turn off the engine, uninstall the OEM ECU and re-install GET
RX1 Pro ECU.
5. Repeat steps 1, 2, 3 of "Idle regulation".
F. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative on the Restriction of
the Use of Certain Hazardous Substances.
G. DISPOSAL
Pursuant to art. 26 of Legislative Decree no. 49 of 14
March 2014, "Implementation of Directive 2012/19/
EU on waste electrical and electronic equipment
(WEEE)".
The crossed-out wheelie bin symbol displayed on a product or its
packaging indicates that when the equipment reaches the end of
its life cycle it must be disposed of separately from other waste
for purposes of treatment and recycling. Once such products reach
the end of their life cycle, users may dispose of them free of charge
at special municipal centres for the collection of waste electrical
and electronic equipment, or return them to the distributor under
one of the following arrangements:
- very small products, i.e. equipment with no external dimension
exceeding 25 cm, may be returned with no obligation to buy
to distributors whose sales areas dedicated to electrical and
electronic equipment exceed 400 m2. Distributors with smaller
sales areas are not obliged to participate in this scheme.
EN
6