Bosch sensixx B35L Instrucciones De Uso página 11

All manuals and user guides at all-guides.com
Thank you for buying the sensixx B35L steam
station, the new steam-ironing system from
Bosch.
Carefully read through the operating instructions
for the appliance and safeguard them for future
reference .
Introduction
These instructions for use contain valuable information
about the unique features of this system and some
hints to make ironing easier for you.
This powerful system produces non-stop steam for an
ideal ironing performance. It has a large detachable
water tank that can be refilled at any time without
switching off the system. We hope that you enjoy
ironing with this steam station.
Important
Open out the first page of the booklet, this will help you
to understand how the appliance works.
This appliance complies with international safety
standards.
This appliance has been designed exclusively for
domestic use and must not be used for industrial
purposes.
This appliance must only be used only for the purposes
for which it was designed, i.e. as an iron. Any other
use will be considered improper and consequently
dangerous. The manufacturer will not be held
responsible for any damage arising from misuse or
improper use.
General safety instructions
• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an earthed
socket. If it is absolutely necessary to use an
extension cable, make sure that it is suitable for 16A
and has a socket with an earth connection.
• The iron should not be used if it has been dropped,
if there are visible signs of damage or if it is leaking
water. It must be checked by an authorized Technical
Service Centre before it can be used again.
• If the safety fuse fitted in the appliance blows, the
appliance will be rendered inoperative. To restore
normal operation the appliance will have to be taken
to an authorised Technical Service Centre.
• In order to avoid that, under unfavourable mains
conditions, phenomena like transient voltage drops or
lighting fluctuations can happen, it is recommended
that the iron is connected to a power supply system
with a maximum impedance of 0.27
Ω
en
11