Publicidad
Idiomas disponibles
Idiomas disponibles
FORWARD/REVERSING LEVER & TRIGGER LOCK
Your tool is equipped with a forward/ reversing lever and trigger lock (Fig.1) located
above the trigger. This lever was designed for changing rotation of the chuck, and for
locking the trigger in an "OFF" position to help prevent accidental starts and accidental
battery discharge. For forward rotation, (with chuck pointed away from you) move the
lever to the far left. For reverse rotation move the lever to the far right. To activate trigger
lock move lever to the center "off" position.
MOUNTING AND DISMOUNTING THE BIT
Mounting the bit
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as
viewed from the front) to open the clip on the keyless chuck. After inserting a driver bit,
etc., into the keyless drill chuck, tighten the sleeve by turning it toward the right (in the
clockwise direction as viewed from the front).
NOTE: If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
DISMOUNTING THE BIT
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as
viewed from the front), and then take out the bit.
DRILLING
Place the bit on the work surface and apply firm pressure before starting. Too much
pressure will slow the bit and reduce drilling efficiency. Too little pressure will cause
the bit to slide over the work area and dull the point of the bit. If the tool begins to stall,
reduce pressure slightly to allow the bit to regain speed. If the bit binds, reverse the
motor to free the bit from the workpiece.
TORQUE ADJUSTMENT
By turning the adjustment ring (Fig.1) the required torque can be adjusted. The arrow
aligns with the adjusted state.
The tightening torque is affected by a wide variety of factors including the following.
Forward/Reverse Switch
See Fig. 1
Voltage
When the battery pack becomes nearly discharged, the voltage decreases and the
tightening torque drops.
NEVER
place hands or other body parts near the drill bit or chuck during operation.
Hold the drill by its handle only. Because the cordless driver drill operates by battery
power, be aware of the fact that it can begin to operate at any time.
When battery pack is not in use, keep it away from other metal objects like paper clips,
coins, keys, nails, screws, or other small metal objects that can make a connection from
one terminal to another. Shorting the battery terminals together may cause burns or a fire.
All manuals and user guides at all-guides.com
11
Publicidad
