Noise/Vibration Information - REICH 3590 Datos Técnicos

4 I English
1 TECHnICAL DATA
Type
Dimensions mm
Weight kg (without fasteners)
single sequential or contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity. no. of
fasteners
Penetration depth setting
Fasteners: plastic bound nail coils
nail length mm
nail shank Ø mm
Recommended lubricant
1 litre special oil. Code no.
250 cm3 grasa especial. Code no.
2

nOIsE/VIbRATIOn InFORMATIOn

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a),
a h, w, 3s
The noise level when working can exceed 85
db (A). Wear ear protection!
* Measured values determined according to
En 12549:1999.
** Measured values determined according to
IsO 8662-11:1999.
3 suPPLIED WITH
1 Coil nailer
1 Tool use and safety instructions
1 Technical data sheet
Karl M. Reich Verbindungstechnik GmbH
4
3590
Only those fasteners specified under technical data
(see 1) may be used.
380/390
When filling the magazine, hold the tool so that the
4.0 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
6 - 8 bar/
yoke or trigger depressed.
0.6 - 0.,8 MPa
First, remove the rubber band from the nail coil.
To open the magazine, open the guide flap (k) using
8 bar / 0,8 MPa
the notch lever (l) and swing open the magazine (m).
2.7 l at 7
Insert the nail coil in such a way that the beginning of
bar / 0.6 MPa
the coil is in the driver channel. The nail coil has to be
able to move freely.
The nail support (n) can be adjusted in several planes
225-300
by means of the setting wheel (o) for corresponding
yes
nail lengths in the magazine.
Close the magazine and lock the guide flap.
60-90
2.8-3.1
5
The penetration depth of the nail head is adjusted
9 4420
using air pressure. Should this not suffice, a more
68 3868
exact setting of the penetration depth can be achieved
by turning the setting nut (p).
Right-hand turn (u) = less penetration depth.
Left-hand turn (D) = more penetration depth.
3590
6
-sInGLE TRIGGER RELEAsE/RELEAsE On COnTACT-
97.1 dB(A)
A setting button on the trigger (s) can be pressed or
pulled to set the type of actuation either to single
108.5 dB(A)
trigger release or release on contact (see symbol).
7
4.7 m/s2
before the plastic strip, now without nails is disturbing,
knock the cutting knife (u) so that the strip is detached.
8
balancer for 30-55 n (3.0-5.5 kp),
cable travel 2.0 m.
Protection cap
FILLInG THE MAGAZInE
FIL PEnETRATIOn DEPTH sETTInG
sWITCHAbLE ACTuATIOn
HAnDLInG THE TOOL
ACCEssORIEs
3590
Code No.
28 6478
78 8205
REICH ®