in-lite SCOPE BASE PLATE Manual De Instrucciones página 9

EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first. Do not open the
spotlight yourself.
Step 1
Remove the butterfly screw from the toothed coupling of the housing.
Push the mini-connector through the opening in the base plate. Attach
the base plate to the lamp by placing the two toothed coupling halves
on top of one another. Place the cable in the recess intended for this
purpose. Stick the butterfly screw through the hole in the base plate
and tighten it. Decide how you want your lamp to be positioned before
you tighten the butterfly screw fully. Take the cable through the notch
in the side of the base plate or drill a hole of 13 mm / 0.5 inches
diameter below the base plate for the cable to go down. (Fig. 1)
Step 2
Attach the fixture to the hard surface using both screws. If it is neces-
sary to drill holes for the screws then use the template supplied. Use
the two screw caps to cover the screws in the base plate. (Fig. 2)
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 3)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
All manuals and user guides at all-guides.com
Step 4
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 4)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.