Descargar Imprimir esta página

Consumer Safety Information; Cord And Plug Installation Safety Instructions; Instructions Before Use; Filling The Water Tank - Bionaire BU6000 Manual De Instrucciones

Ocultar thumbs Ver también para BU6000:

Publicidad

Idiomas disponibles

Idiomas disponibles

GENERAL DESCRIPTION (SEE FIG. 1)
A. Mist nozzle
B. Water Tank
C. Water View Window
D. Water Tank Cap
E. Humidifier Base
F. Power Cord
G. Airflow outlet
H. Control Knob
I. Power/Low Water indicator light
J. LED Night Light
K. Transducer
L. Cleaning Brush
M. Water Basin
N. Drain Outlet
O. Water Level Sensor
Fig. 1
A
B
C
D
E
F
G
H
OPERATING INSTRUCTIONS

Consumer Safety Information

NOTE: This is an electrical appliance and requires
attention when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty
of humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
All manuals and user guides at all-guides.com
Cord and Plug Installation
Safety Instructions:
The length of cord used on this appliance was selected
to reduce the hazards of becoming tangled in, or
tripping over a longer cord. If a longer cord is necessary
an approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the humidifier (refer to the rating
information placed on the humidifier). Care must be
taken to arrange the extension cord so that it will not
drape over the countertop or tabletop where it can be
pulled on by children or accidentally tripped over.

Instructions Before Use

1. When using the humidifier for the first time
2. The suitable working environment for the humidifier
3. Select a location for your humidifier, on a flat surface,
4. Be sure the humidifier is disconnected from the

Filling the Water Tank

O
WARNING: DO NOT pour water into the mist nozzle
on top of the humidifier. DO NOT pour water directly
into the water basin as this may cause damage to
N
the unit. Always follow below steps to fill or refill
M
water.
1. Remove the water tank from the humidifier unit. See
L
K
2. Bring the tank to the sink, turn upside down and
J
I
2
after being removed from its original box, it is
recommended to place the unit at room temperature
for about 30 minutes before operation.
is: temperature at 5°C-40°C (41°F-104°F) and
relative humidity less than 80%RH. DO NOT operate
the humidifier with the environment condition exceed
the recommended temperature and relative humidity
ranges.
at least 4 inches (10 cm) away from the wall. DO
NOT place the humidifier on a finished floor or
near furniture, which can be damaged by too much
moisture or water. Place on a moisture resistant
surface.
electrical outlet and the unit control knob is switched
to standby (
) position.
Fig. 1 for your reference.
twist off the tank cap by turning counter clockwise.
Fill tank with cool, fresh tap water with temperature
below 40°C (104°F). DO NOT fill with warm water
with temperature higher than 40°C (104°F) as this
may cause the unit to fail. Place the cap back on
tank and turn firmly clockwise to complete this step.
See the figure below for reference:
(1)Remove the tank cap
(2) Fill with cool fresh tap water
(3)Replace the tank cap

Publicidad

loading