Vivanco UR 5000 Instrucciones Para El Uso página 6

All manuals and user guides at all-guides.com
UR 5000 UNIVERSAL CONTROLLER
remote controls and start capturing the key
function again at step 6.
9 Press and release device key for exit of
learning mode. – The controller will exit the
learning mode automatically after about 15
seconds of inactivity.
In case a copied key operates occasionally
only, please try the following modified
method:
1. Please follow steps 1 to 5 as explained
above.
2. Press and release the target key, that
you want to learn to (reprogram) (e.g.
POWER), the UR 5000 will peep.
3. Press and hold the source key on the
original remote control (e.g. POWER) until
the LED on your UR 5000 remote control
blinks once and the device icon, e.g. DVD will
flash again.
4. Press and release the same UR 5000
target key again for repeated learning. The
Device Key icon (e.g. DVD icon) will stop
flashing.
5. Press and hold the same source key on
the original remote control (e.g. POWER)
until the LED on your UR 5000 remote control
blinks once and the device icon, e.g. DVD,
will flash once again. That indicates that a
new function code, e.g. POWER, has been
learnt.
6. Repeat steps 2 to 5 of this procedure to
copy further keys, if needed..
7. Press and release device key for exit of
learning mode.
Reset/deletion of all captured key functions
per device: Entering a new pre-programmed
Device Code, see above Direct control
code entry using the enclosed list, will
automatically erase and replace all learned
commands in the chosen device mode.
If you enter
Memory full indication: if the memory is full,
the LED (2) blinks 3 times and then press
and release device key to exit learning
mode..
Operation
You operate your appliances basically in
Vivanco GmbH, D-22926 Ahrensburg, E-Mail:
hotline@vivanco.de, Helpline: +49 (0) 4102 231135 6