Publicidad
Idiomas disponibles
Idiomas disponibles
Configuring Your Phone
Configuring via web user interface
Accessing the web user interface:
1. Press
when the phone is idle to obtain the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10") and press Enter.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click
Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If the phone cannot contact a DHCP server for any reason, you need to configure
the IP address, subnet mask, gateway address, primary DNS address and
secondary DNS address for the phone manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the user name and password.
Note: The wrong network settings may result in the inaccessibility of the phone and may have an impact on the
network performance. Contact your system administrator for more information.
Account Settings: Click on Account->Register
Parameters of the account:
Register Status:
It shows the register status of the current account.
Line Active:
You can select Enabled/Disabled to enable/disable the account.
Label:
It is shown on the LCD to identify the account.
Display Name:
It is shown as caller ID when placing a call.
User Name:
It is provided by ITSP for registration (required).
Register Name:
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
Password:
It is provided by ITSP for registration (required).
Server Host:
Register status icons on the LCD screen:
Registered
Note: Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Configuring via phone user interface
Network Settings:
Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:
admin) ->Network->WAN Port/VLAN/Webserver Type/802.1x Settings to configure the network.
Account Settings:
Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:
admin) ->Account to configure the account.
Note: For more information on account parameters, refer to Configuring via web user interface.
All manuals and user guides at all-guides.com
Register Failed
Registering
E
N
G
L
I
S
H
3
Publicidad
