Panel Facilities - Pioneer S-VW02 Manual De Instrucciones

PANEL FACILITIES

FRONT PANEL
1
STANDBY/ON
POWER
2
REAR PANEL
LINE LEVEL
INPUT
AUTO
6
STANDBY PHASE
OFF ON 0 180
7
240V
220-
230V
110-
127V
AC IN
CROSSOVER VOLUME
3
4
5
LINE VOLTAGE
SELECTOR
SWITCH
8
1 Power indicator (STANDBY/ON)
Lights red when the power has been switched ON.
Lights green when the speakers receive an audio
signal. If the power is switched OFF only briefly, the
indicator lights green when power is restored. If no
signal is present for more than 8 minutes, the
subwoofer automatically reverts to standby mode and
the power indicator lights red. If, subsequently, a signal
is received, power automatically comes back on and
the power indicator lights green.
2 POWER switch
Pressing once switches the unit ON. Press again to
switch OFF.
NOTE:
If you are planning on switching the unit OFF for a long
period of time, make sure to check that the indicator light
has gone out after switching OFF.
3 Volume knob (LEVEL)
Sets the subwoofer volume.
• Turn the knob slowly from the MIN position.
• With this unit, the bass level can be independently set,
so do not turn up the bass on the stereo amplifier.
4 Crossover knob (CROSSOVER)
Sets the high limit of the frequency played back by the
subwoofer. Set to MAX when using the supplied
speaker system.
Setting Criteria
MIN.................. when the diameter of the left/right
speakers is 20 cm or more.
CENTER........... when the diameter of the left/right
speakers is 10-25 cm.
MAX................. when the diameter of the left/right
speakers is 12 cm or less.
5 Line Level Input terminal
(LINE LEVEL INPUT)
Connects to the stereo amplifier's SUBWOOFER PRE-
OUT terminal, with the specially provided RCA plug
cord.
6 Auto Standby switch
(AUTO STANDBY)
Switches the Auto Standby feature on/off.
Auto Standby
When switched ON (the default setting is OFF), the
Auto Standby feature becomes active. In this mode, if
there is no input signal for eight minutes the system
automatically switches to standby. The power is
automatically switched on again if an input signal is
detected.
NOTE
• There may be cases where a connected component
outputs noise or some other non-audio signal which
causes this system to automatically power on when in
Auto Standby mode. If this happens, switch off the Auto
Standby mode and switch the system on/off manually.
7
En