Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Setting current time
10
2
3
With the remote control ON or OFF, press button [10] for at
least 5 seconds.
1
The displayed current hour [S] figure flashes.
Press either button [2] or [3] to set the desired value.
2
Press button [10] to confirm. The minutes figure flashes.
3
Press either button [2] or [3] to set the desired value.
4
Once the current time is set, press button [10] to confirm.
5
Operating mode selection
4
By repeatedly pressing button [4] the available modes will be selected
in sequence.
The choosen mode is shown on the display as follows, while the unit
will acknowledge signal receipt with a confirming beep.
[ 1] Ventilation (fan only)
1a
[ 3] Automatic (set the right mode for the desired
1b
temperature)
[ 4] Cooling with dehumidification
1c
[ 5] Dehumidification only
1d
[ 2] Heating (if available)
1e
Temperature setting
2
3
Press the UP [2] and DOWN [3] buttons to increase or decrease the
temperature from the previously set value.
The unit will confirm signal receipt with a beep, and the value
of the set temperature on the display will change accordingly.
The temperature can be set between 17°C (63°F) and 32°C
(90°F) at 1 degree intervals.
Note
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for
the heating mode, if the selected temperature is lower than
the room temperature.
S
1
2
3
C
E
F
4
5
F
3 3
Publicidad
