Leggett & Platt G-SMR-2 CUSTOM Manual De Operaciones página 9

g-smr-2 custom remote controL programming (2 remote controls - 2 bases)
Program Two Remotes to Operate Two Bases - your
adjustable base will be equipped with one of the
following: (A) a DC motor with a power down box, (B)
an AC J box, (C) a DC motor without a power down box
(FIGURE 2). NOTE: operate only one (1) remote control
at a time. Operating two (2) remote controls at the
same time will momentarily block both rf signals and
prevent both controls from functioning.
a
POWER
DOWN BOX
LEARN
BUTTON
b
AC J BOX
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
c
DC MOTOR-NO
POWER DOWN
BOX
FIGURE 2: Power down box, AC J box and DC motor.
step 1 (base 1)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
box: unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back into
the power source.
step 2
On remote control 1, simultaneously press and
hold the POS 1 and head massage on/off buttons
(FIGURE 3). The transmission indicator light will
flash slowly and then flash rapidly to indicate
programming mode. Continue to hold for 5 seconds
and then release the buttons.
step 3
POWER DOWN
BOX (NOT
Repeat Step 1 and Step 2 with remote control 2.
MOUNTED TO
step 4 (base 2)
BASE FRAME)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
LEARN
box: unplug the adjustable base electrical power
BUTTON
cord. Wait 30 seconds, then plug the cord back into
the power source.
step 5
On remote control 1, simultaneously press and
hold the POS 1 and head massage on/off buttons
(FIGURE 3). The transmission indicator light will
flash slowly and then flash rapidly to indicate
programming mode. Continue to hold for 5 seconds
and then release the buttons.
step 6
DC MOTOR
(MOUNTED TO
Repeat Step 4 and Step 5 with remote control 2.
BOTTOM SIDE OF
Two remote controls are now programmed to operate
BASE FRAME)
two bases.
G-SMR-2 Custom Remote Control Operation Guide 99300822-e
REMOTE REMOTE
CONTROL 1 CONTROL 2
POS 1
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
FIGURE 3
BASE 1
BASE 2
TRANSMISSION
INDICATOR LIGHT
9