Publicidad
Idiomas disponibles
Idiomas disponibles
Analog detectors and bases
2.
Tighten the base to the mounting surface. Do not over tighten. If you use a 6-inch base, fit
the base skirt onto the mounting base.
3.
Turn clockwise until the detector head locks into place and aligns with the semi-circle
notch (4).
3.2
Locking and Releasing the Detector
The detector bases are supplied with a snap-off locking bar (X) as part of the base moulding
to prevent malicious removal of the detector. The locking mechanism is selectable and is
activated by shifting the U-shaped locking bar (X) into the position as shown.
1.
Remove the U-shaped locking bar by breaking it from its holder.
2.
Tuck it into the opening next to it by pushing hard.
3.
Insert the detector head into the base.
X
Figure 3.2: Activating the Locking Mechanism
4.
Release the locked detector head by pushing hard through the dimple (O) on the
detector's outer rim with a screwdriver and at the same time, turning the detector head
to the left.
O
Figure 3.3: Releasing the Detector
Bosch Security Systems, Inc.
All manuals and user guides at all-guides.com
X
Installation Guide
Mounting | en
7
O
2018.08 | 6.0 | F.01U.123.589
Publicidad
