Cleaning And Maintenance; Changing Light Bulbs; Problem Solving - Teka CC 40 Manual De Instrucciones

Filter saturation indicator "F"
When the sign 'Saturation of the filters' is on, the filters
should be cleaned.
After cleaning the filters, simultaneously push "+" and "-"
for at least 3 seconds whereupon the sign will be switched
off.

Cleaning and maintenance

During cleaning and maintenance work, make
use proprietary cleaners mentioned in the product
instructions.
and a neutral soap.
products.
produce fibres.
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does not
The lamps do not light up.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their
useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems

Problem solving

Possible cause
The mains cable is not connected to
the network.
There is no current in the network.
Filters are saturated with fat.
Obstruction in the air outlet.
The lamps are blown
The lamps are slack.
Cleaning the metal filters
To remove the filters from their fittings, press lightly on the
locks and then pull them off.
The metal filters can be cleaned by soaking them in hot
water with neutral detergent until the fat dissolves and then
rinsing them under the tap or using special anti-grease
products. They can also be washed in a dishwasher. In this
case, it is advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic surface
capacity.
Once clean, leave them to dry off and then fit them onto
the kitchen hood.

Changing light bulbs

Proceed as follows:
Solution
Connect the mains cable to the network.
Provide current to the network.
Change or clean the active
Remove the obstruction.
Change the lamps.
Tighten the lamps.