Vision TECHCONNECT IR Manual De Instrucciones página 6

All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
The Techconnect IR Control is designed to replicate the function of your projector or flat-panel
IR remote control. By using the Techconnect Control you will present users with a standardized
way of controlling their equipment, and the original remote control can be safely locked away.
1. SEPARATE FRONT PANEL FROM REAR Gently separate the front panel from the rear chassis.
The front panel is held on by clips on each side towards the front.
2. LOAD BUTTONS The front panel comes pre-loaded with a common configuration of buttons.
You will need to change buttons to suit the projector you are controlling. For example, if the
remote control you are learning from has separate on and off buttons, you will need to use that
button set in the Techconnect Control. Likewise for the source selection buttons some projector
remotes use a single toggle button to select inputs, while other remote controls use more
buttons. If your projector remote control has four separate buttons for each input (e.g. PC1,
PC2, Video, S-Video), then you should install the "PC1/2 / VID1/2" button set in the middle of
the front panel. Re-attach the front panel to the rear chassis.
3. SELECT DUAL OR SINGLE COMMAND FOR MIDDLE BUTTONS The "Single/Dual
Command" switch on the rear selects whether you want the middle buttons to learn one code
each, or two discreet codes each. If your projector remote control has four separate buttons for
each input, then you should set this to "Dual". For all other circumstances you only need the
middle buttons to learn one code each, so it should be set to "Single".
4. LEARN CODES FROM ORGINAL REMOTE CONTROL To program each button follow these
simple steps. In this example we will program the power button. Before you start ensure that the
batteries are installed by pressing any one of the buttons on the front panel – you will hear a
"beep".
a) Press the "Learn" button on the rear. The red LED will light up and stay lit.
b) Press the button on the front panel you want to assign the code to - in this example the
power button.
c) Point the original remote control at the "IR Input" receiver on the back of the module.
Press and hold the power button on the remote control until the green confirmation LED
lights briefly on the rear of the module. It will normally take 1-2 seconds.
4