Publicidad
Idiomas disponibles
Idiomas disponibles
Ofrecido por www.electromanuales.com
•
Timeshifting may be stopped according to USB
device write speed. If the USB device speed is not
enough for video stream bitrate, timeshifting may
be stopped and recording may fail. If HD service
bitrate is greater than 13 Mbp/sec. some freeze can
be seen during timeshifting on both USB disk and
on external HDD.
•
Recordings of HD programmes can occupy bigger
size on the USB disk depending on the broadcast's
resolution. For this reason it is recommended
to use USB hard disk drives for recording HD
programmes.
•
Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
•
Multipartiton support is available. Maximum two
different partitions are supported. If the disk have
more than two partitions, crash may occur. First
partition of the usb disk is used for PVR ready
features. It also must be formatted as primary
partition to be used for PVR ready features.
•
Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
•
Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.
• Radio record is not supported.
• The Tv can record programmes up to ten hours.
Connecting the LCD TV to a PC
For displaying your computer's screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LCD TV. When the connection
is made, switch to PC source. See "Input selection"
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts.
Using Side AV Connectors
You can connect a range of optional equipment to your
LCD TV using side connectors of the TV.
•
For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
•
Afterwards, you should switch to
the section Input selection in the following sections
for more information.
•
To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above.
Connecting to a DVD Player via HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
•
If your DVD player has an
connect via HDMI for better video and audio quality.
•
When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
English - 50 -
Side AV source. See
C amco r de r
H e adp h o n e
HDMI socket, you can
H D MI C a b l e
( n o t s u p p l i e d )
External device
Publicidad
