Publicidad
Idiomas disponibles
Idiomas disponibles
5
. Turn on and enter network configuration status
1-Remove the base of the doorbell and open the black silicone gasket on
the back of the doorbell.
2-Turn the power switch key to "ON" and the video doorbell turns on. After
powering on, press and hold the reset button "RESET" for 8 seconds until the
doorbell sounds "System reset", Then the doorbell will restart automatically,
and the indicator light will go out, red light turn on, then blue light flashes. When
you see the blue light flashing, you will hear the prompt tone "The camera is
ready to begin pairing" and the doorbell enters network configuration status.
16
Charging port
Reset button
Silicone cap
Power key
TF card interface
Publicidad
