Publicidad
Idiomas disponibles
Idiomas disponibles
10. TRANSFER OF PRE-RECORDED MESSAGES TO THE DC-800ETH
The paging desk incorporates an internal Micro SD memory with a capacity of 15 GB to store audio files to be used as pre-recorded
messages.
To save files in this internal memory requires a PC with the PA Manager software installed and equipped with a network card, and
connected to the DC-800ETH unit through a switch or directly using a network cable (see section 9. COMMISSIONING THE UNIT).
The allowed audio file formats are wav, ogg and mp3.
Follow the PA Manager software user manual to copy the files to the Micro-SD memory of the DC-800ETH.
11. GENERAL OPERATIONS
11.1. User levels and changes
To restrict the access to specific functions of the paging desk, 3 user levels have been established. Basic, Operator and
Administrator.
Basic
Level by default when the paging desk is booted. Without an access code. Allows conducting basic operations such as broadcasting
live voice announcements or sending pre-recorded messages. It cannot modify the volume, configuration of music channels,
message recording, network addresses or adjust the display contrast.
Operator
With access code (by default 1234). The access code may be changed via the PA Manager software; It must be a four-digit number.
In addition to all the permissions granted to the basic user, he can configure the volume of the zones (except the emergency
volume), modify the music channels, record messages and or adjust the contrast of the display. It cannot modify the emergency
volume, or network addresses.
Administrator
With access code (by default 1234). Without restrictions. The access code may be changed via the PA Manager software.
A. Login as an ADMINISTRATOR USER
Using the / navigation keys, select the settings
1.
menu ( ).
Using the / keys select USER and press OK.
2.
Using the / keys select LOGIN DMINISTRATOR and
3.
press OK.
4.
Enter the administrator user code (1 2 3 4 by default)
and press OK.
B. Logout as ADMINISTRATOR
Using the / navigation keys, select the settings
1.
menu ( ).
Using the / keys select USER and press OK.
2.
Using the / keys select LOGOUT ADMINISTRATOR
3.
and press OK.
DC-800ETH version 4.3.001
DC-800ETH
C. Login as an OPERATOR USER
Using the / navigation keys, select the settings
1.
menu ( ).
Using the / keys select USER and press OK.
2.
Using the / keys select LOGIN OPERATOR and press
3.
OK.
4.
Enter the operator user code (1 2 3 4 by default) and
press OK.
D. Logout as OPERATOR
Using the / navigation keys, select the settings
1.
menu ( ).
Using the / keys select USER and press OK.
2.
Using the / keys select LOGOUT OPERATOR and
3.
press OK.
IP Microphone desk
and Control central
R + D Department
15
Publicidad
