Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the backflow flap
If the cooker hood does not have a pre-assembled backflow flap, install the parts
as follows:
1.
Install the first half (2) into the housing (6).
2.
The pin (3) should be facing upwards.
3.
The axle (4) is inserted into the holes (5) on the housing.
4.
Repeat all the steps for the second half of the flap.
Preparation
If you have an extractor to the outside, you can install
the extractor hood as shown in the picture on the
right. The flue should have a diameter of at least 150
mm and be made of enamel, aluminium or a flexible,
heat-resistant tube.
•
Switch off the device before installation and pull
the power plug out.
•
The extractor hood should be placed at a height of
65-75 cm above the hob.
EN
27
Publicidad
