Publicidad
Idiomas disponibles
Idiomas disponibles
18 | English
Problem
Possible Cause
Garden tool does not
Cutting line too short/broken off
cut
Spool empty
Line retracts into spool Cutting line too short/broken off
Line breaks frequently Line inside the spool entangled
Trimmer used incorrectly
Diameter of cutting thread is too small
Heavy vibrations
Cutting line broken
Imbalance in cutting head or cutting blade
Protection guard incorrectly mounted
Nut for blade mounting has become loose
Maintenance and Service
Maintenance, Cleaning and Storage
Before any work on the garden product itself (e. g.
u
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
garden product. There is danger of injury when uninten-
tionally actuating the On/Off switch.
For safe and proper working, always keep the product
u
clean.
Clean and maintain the product before storage.
Do not place other objects on the garden tool.
To ensure safe and efficient operation, always keep the
product and the ventilation slots clean.
Never spray the product with water.
Never immerse the product in water.
Store the product in a secure, dry place, out of the reach of
children.
Do not place other objects on the product.
Do not leave the product on the ground. Trip hazard!
Keep all nuts, bolts and screws tight to ensure safe working
with the product.
Inspect the product and replace worn or damaged parts for
safety.
Ensure replacement parts fitted are Bosch-approved.
The product must not be modified, any modification made
may cause injuries.
Sharpening and Balancing the Cutting Blade
Correct sharpening and balancing of the cutting blade re-
quires a lot of practice. Bosch recommends that you use an
approved replacement cutting blade. Replacement cutting
blades can be purchased from an approved service centre.
F 016 L94 068 | (14.01.2022)
Corrective Measure
Feed cutting line using manual feed button (see
figure J)
Replace the spool (see figure J)
Remove spool – rethread line (see figure J)
Remove spool – rewind line (see figure J)
Only trim with the tip of the line, avoid touching
stones, walls and other hard objects. Feed the
line regularly to maintain full cutting diameter.
Use recommended cutting line
see figure J
Remove any mud/contamination from the cutting
head. Check the cutting head and contact Bosch
customer service agent in case of damage
Mount protection guard correctly
Tighten the nut for blade mounting (20 Nm)
Transporting the Brushcutter
For transport and storage, always protect the cutting blade
with a suitable cover.
Carry the brushcutter in one hand, well balanced on the
shaft, with the cutting adapter pointing to the rear.
Secure the brushcutter against tipping over and shifting dur-
ing transport.
Battery Maintenance
Use the following procedures to enable optimum usage of
the battery:
– Protect the battery against moisture and water.
– Store the machine and battery only within a temperature
range between –20 °C and 50 °C . As an example, do not
leave the battery in the car in summer.
– It is recommended that the battery is not stored within
the product but stored separately.
– Do not leave the battery in the product in direct sunlight.
– The ideal storage condition for the battery is 5 °C.
– Occasionally clean the venting slots of the battery using a
soft, clean and dry brush.
A significantly reduced working period after charging indic-
ates that the battery is used and must be replaced.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Bosch Power Tools
Publicidad
