Hendi 222157 Manual Del Usuario página 7

Coupling
Disassembly:
1. Hold the coupling of the blending part (7) and
screw out the blade (8) by anti-clockwise until it
is fully detached.
2. Hold the blending part (7) and pull out the shaft.
Suitable for:
Preparation:
Maximum continuous op-
eration time
• Once connected to the power plug, "3" will be
shown on the LCD display (4).
• Lower the blending part (7) into the food contain-
er (not supplied). Fully submerge blade (8) into
the ingredients before starting the appliance.
ATTENTION: You should not submerge the blend-
ing part (7) above the Max. mark.
• Hold the main unit (10) firmly with one hand and
the mixing container with the other hand.
• Press and hold the ON / OFF button (1), the appli-
ance then starts blending continuously.
• Use a gentle up-and-down motion to blend the
food ingredients smoothly.
• To avoid food spattering, do not lift the appliance
out of the ingredients during operation.
Shaft
• Blending juices and shakes
• Mixing soft ingredients (e.g. pancake batter or mayonnaise).
• Mixing vegetables into soup (e,g. carrots, etc.)
• Peel or pare food and cut them into small chunks.
• Place the food into a suitable container of capacity 1~4 litres.
3 minutes to prevent motor overheated. Operate the appliance again after
cool down.
Assembly:
1. Insert the shaft into the blending part (7) until it
is fully inserted.
2. Hold the coupling of the blending part (7) and
screw in the blade by clockwise until it is fully
tightened.
• Select the blade speed by pressing the + (2) or
- (3) button (Speed range: 1 to 6) during opera-
tion. The blade speed will be shown on the LCD
display (4).
Note: No need to press the ON/OFF button (1) when
selecting the blade speed simultaneously.
• After finish operation, release the ON / OFF but-
ton (1) to switch off the appliance.
• Wait until the blade (8) stop completely. Then, un-
plug it from the electrical supply.
• Turn the main unit (10) clockwise to disassembly
the blending part (7) for cleaning.
Note:
1. Press and hold the decreasing and increasing
button + (2) or - (3) button for fast adjustment.
2. The default blade speed will be set to "3" once
plug in.
8
EN
7