Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE THE FIRST USE
Before using the Steam Station, please ensure you read the user manual and understand all parts
and features of the Steam Station. Be sure to remove any packaging material and labels before using
for the first time.
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on
clothes and there may be traces of dirt on the soleplate
WATER TO BE USED
The device is designed for use with tap water. If the water in your area is hard or semi-hard use mix
tap water with distilled or demineralized water purchased in stores, in the ratio 2:1 and 1:1 respectively
(distilled water: tap water). Check with your water supplier to determine the type of water in your
area. Never use 100% distilled or demineralized, rain water, softened water, scented water, water
from other appliances such as refrigerators, air conditioners, dryers or other types of home water
preparation water.
FILLING THE WATER TANK
Locate the water tank release latch under the front of the water tank and push up. This will release the
water tank, enabling you to pull it out.
Place the water tank inlet under a tap and fill. Do NOT fill over the MAX level indicator.
Slide the water tank back in position and push in, you will hear it click when it is locked in place.
OPERATING INSTRUCTIONS
1. Place the Steam Station on a firm level table, bench or ironing board.
2. Plug the unit into a power outlet and switch on at the power point.
3. Ensure that the steam button is in the unlock position.
4. Press the power button ON. The light will illuminate.
5. The Steam Station will start to boil the water and HEAT indicator light starts blinking .
NOTE: You will hear the boiler pumping water from the water tank through to the boiler. The Pump
indicator light will turn on. This is a normal part of the operation, and will occur whenever Steam
Station boils the water. Do NOT press the steam trigger whilst the Steam Station is heating up.
6. Once the unit is ready for use, the HEAT indicator light will stop blinking and become fixed. Select
the steam level.
7. You are now ready to iron. Adjust the temperature dial on the iron to suit the type of fabric you are ironing.
There are 4 settings in order of temperature: LOW, MED, HIGH, MAX.
Refer to our Ironing Guide Chart in this manual for further information on recommended ironing tem-
peratures.
NOTE: When ironing, the iron temperature indicator light will turn on and off intermittently as it ad-
justs temperature.
8. To generate steam, press the steam trigger and hold down for a steady flow of steam. Once you
release the trigger, steam will stop.
9. For a continuous flow of steam, push the steam control button forward to the lock position. To
stop steam flow, switch the steam control button back to the lock position.
10. Choose between any of the three levels of steam flow to increase or reduce steam flow level: LOW,
ECO , HIGH.
19
Publicidad
