Trouble Shooting - Johnson 40-6625 Manual De Instrucciones

8185H-All_Manuals 8/13/14 8:14 AM Page 16

15. Trouble Shooting

• If the unit does not turn on, check the battery polarity or install new
batteries and clean the battery terminals.
• If the laser does not illuminate, check the battery polarity or install new
alkaline batteries and clean the battery terminals.
• If the unit is out of calibration less than 1/2" at 35', follow calibration
procedure in manual.
• If the unit is out of calibration more than 1/2" at 35', contact an authorized
Johnson service center or Johnson Level & Tool's customer service
department.
• If the unit will not calibrate, contact an authorized Johnson service center or
Johnson Level & Tool's customer service department.
• If the unit beeps and/or flashes constantly, check to see if the unit is being
tilted to angles beyond the self-leveling range. If so, push the "horn" button
to engage manual mode. If the unit is being used for a level application,
place onto a surface that is within the self-leveling range. If it is still beeping
and/or flashing, the unit is out of calibration.
• If the unit turns off after a short time, install new alkaline batteries and
clean the battery terminals. Also, make sure that the on/off knob is in the
on position.
16
All manuals and user guides at all-guides.com
©2014 Johnson Level & Tool - Rev. 3