URBANGLIDE ECROSS PRO Manual Original página 26

Remove the rubber cap, insert the charger into the charging port on your scooter. Once charged, put the
cap back on and make sure it's on and sealed.
When charging your scooter, make sure the charging port is in good condition and that no residue is stuck
in it. If it is, clean it with a dry cloth. Use the charger supplied with the product, and only that charger. If
you have lost your charger, or it is defective, contact Urbanglide support. Once the charger shows a green
light, unplug your product. Do not leave the charger plugged in for too long after charging is complete.
Increase the level of speed /
Light
On/Off
Reduce the speed level
Charging and power supply
Your device is charging. Please wait until the red LED turns
green.
If the LED is green then your device is charged, unplug it and
also unplug the charger from its power source.
Ecran
20
00001
Battery level
26
3
Speed level
Speed in Km/h
Distance travelled in Km