Programming - Waeco MagicSafe MS150 Instrucciones De Montaje Y D’uSo

MSK-150_09092003.qxd
Disarm the magic safe MSK-150.
Turn the ignition on and off twice and then turn
the ignition back on within a 7 second period.
The LED flashes for 3 Seconds. After this
3 seconds period, the LED starts to flash once
per second. After the number of flashes equals
to the tens digit of your PIN code,
Turn the ignition on. The LED continuously
flashes for 1 second. After this 1 second period,
the LED starts to flash once per second. After
the number of flashes equals to the units digit
of your PIN code, turn the ignition off.
If the PIN code is entered correctly, you receive
two receipt signals as confirmation. Turn on the
ignition again. You are now on position 1 of the
main register, which is indicated by a receipt
signal. By means of the blue button you can go
forward in the register, by means of the grey
one backward. The LED shows the current
adjustment of the register. To change the
register where you are, push both buttons of
Turn the ignition off and wait 15 seconds
until you leave the coding software.
The factory adjusted PIN code is 11.
16.03.2004 8:19 Uhr
All manuals and user guides at all-guides.com

Programming

turn the ignition off.
the hand transmitter.
Seite 42
42
To change the
status of the
switch, press the
blue button to
change fom OFF
to ON or the grey
button to change
ON to OFF and
press both buttons
to confirm the new
settings.