Problem Solution; Maintenance; Environmental Protection; Declaration Of Conformity - Worx WX381 Manual Original

Chiseling with an required bit angle
Temperature dependent overload
protection
Protection against deep discharging
****NOTE: The SDS keyless chuck adaptor
illustrated or described in operation table or figures
is not included in WX381 WX381.X delivery. It is sold
separately.
FUNCTION SELECTION
12 12
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide drill bits
should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before
drilling a large diameter hole.

5. PROBLEM SOLUTION

1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
20V Cordless Brushless Rotary Hammer
See Fig. L2
/
/
For hammer drilling in concrete,
brick and stone
For drilling into steel, wood and
plastics
For chiseling into concrete, brick
and stone
For bit rotation
Charging time problems, having not used a battery
pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several
charge and discharge operations by charging &
working with your tool. Heavy working conditions
such as large screws into hard wood will use up
the battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack below
0 C and above 30 C as this will affect performance.
o o

6. MAINTENANCE

Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance, except for the cleaning & lubrication of
the SDS bits and adaptors before inserting into the
chuck. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal
and will not damage your power tool.
7. ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
8. DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
On behalf of Positec declare that the product
Description 20V Cordless Brushless Rotary
Hammer
Type Designation WX381 WX381.X (3- designation
of machinery, representative of Hammer)
Function Hammering various materials
Complies with the following directives,
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
EN