Using Control Panel - Uline H-10029 Manual De Instrucciones

TURN ON UNIT
Press the ON/OFF button on the touchpad.

USING CONTROL PANEL

ON/OFF
Purge
Dehumidifier has one display and four keys. The normal
display messages are:
• DEHUMIDIFIER OFF
• DEHUMIDIFIER ON
• TOTAL HRS
• JOB HRS
• CMPRSR DELAY
• PUMP PURGING
• DEFROST ON
• GET SERVICE ERXX
When the unit is first connected to AC power, the
touchpad display will cycle continuously through three
messages: DEHUMIDIFIER OFF, TOTAL HOURS and JOB
HOURS.
ON/OFF
Press the ON/OFF key to turn on unit. When turning the
machine on, display usually reads CMPRSR DELAY
and performs a numeral countdown from a maximum
of 60 seconds to 0. The compressor delay gives the
machine time to warm up when needed. If compressor
delay countdown is not shown, the machine is ready
to go. Once the unit completes the CMPRSR DELAY, the
display reads DEHUMIDIFIER ON and continues to cycle
between TOTAL HOURS, JOB HOURS and DEHUMIDIFIER
ON. Press the ON/OFF key again to turn off the unit. The
display will read DEHUMIDIFIER OFF.
PAGE 3 OF 18
OPERATION CONTINUED
DISPLAY
Press the DISPLAY key to stop the display at
DEHUMIDIFIER ON or OFF, TOTAL HOURS or JOB HOURS as
it cycles. Press DISPLAY again to restart the display cycle.
CHANGING LANGUAGE DISPLAY
Display
Use the DISPLAY key to change the display language.
Clear
1.
2. While holding down the DISPLAY key, plug in the unit.
3. To change language, press the DISPLAY key or the
4. When the desired language is shown in the display,
CLEAR
Press the CLEAR key to reset the JOB HOURS.
1. As the display cycles between DEHUMIDIFIER ON,
2. Press the CLEAR key to reset the numerals to 00000.
3. Press DISPLAY again to restart the display cycle.
PURGE
Press the PURGE key to empty water from the pump
reservoir. During normal operation, the pump purges
automatically every six minutes or whenever the
reservoir is full. The display will read PUMP PURGING with
a numeral countdown. To purge the pump manually:
1. Turn off the power using the ON/OFF key, and let the
2. Press PURGE to remove residual water.
CAUTION! While in the change-language
mode, pressing other keys can change the
programming of the machine. Do not press
other keys.
Unplug the unit.
The display reads ENGLISH.
CLEAR key.
unplug the unit to set the language.
JOB HOURS and TOTAL HOURS, press the DISPLAY key
when JOB HOURS appears on the screen. That will
make the display read JOB HOURS steadily.
NOTE: TOTAL HOURS reading cannot be reset.
unit sit plugged in for about 10 minutes. This allows
water to drip from the coils and collect in the drip
pan.
0422 IH-10029