Publicidad
Idiomas disponibles
Idiomas disponibles
9. Wall bracket
10. Heater
11. Feet
INSTALLATION
Wall mounting
•
Please note that the product must be installed at least 15 cm
from the floor and 50 cm from the ceiling.
•
The heater must be mounted at 4 points, ensure there is a
300mm clearance on all sides of the heater.
•
Measure the distance between the centre of each bracket both
horizontally and vertically to ensure drilling holes in the correct
place. Mark the positions of the 4 holes to be drilled on the wall
(1), use the supplied wall mount drawings for correct measures.
•
Drill the holes in the wall (2), then insert the plastic expanded
plugs (3) and screw the 4 supplied screws into the plastic
expanded plugs (4).
•
Attached the panel heater onto the screws and move the heater
to the left so that the screws drop into the securing slots (5).
Foot assembly
•
If the heater is not mounted on the wall, the supplied feet must be
fitted to the unit.
•
To fix the feet, remove the bottom screws from the heater
housing.
•
Place the feet and secure them by putting the screws back into
the housing.
•
Take care to ensure that the feet are located correctly on the
bottom end of the heater.
Instruction manual
EN
5
Publicidad
