Romus D-20L Manual De Instrucciones página 38

humidity.
7. To turn off the unit, press ON/OFF button again.
8. Pre-setting function by pressing TIMER button but without turning on the other
functions (including ON/OFF button), you can PRE-SET the time for the machine to work.
For example, if you press the timer to '2', the unit will work automatically after 2 hours.
DRAINAGE :
While the water tank is full, the compressor will stop for self-protection and the water full
indicator will turn into red.
To move the water tank, pull it out squarely from the unit by using the handle at the water
tank.
After empting the water tank, place the water tank into space. Make sure it is properly
positioned, in order for the 'water full' sign to go out and your dehumidifier is operating
Notes :
• Do not move & destroy the float of water tank, or the machine will not able to operate.
• In case the water tank has not been positioned well, the water full indicator will turn
into red.
Continuous drainage
To set the unit up for continuous drainage with the following procedures:
1. Remove the water tank
2. Position the spout as shown in the diagram.
*The unit will not operate without the water
tank, unless the spout is properly positioned.
3. Place one end of an appropriately sized
drain pipe over the spout.
4. Place the other end of the pipe in a drain,
ensuring it is not coiled.
36
Spout for
continuous
drainage
www.romusworld.com www.romusworld.com
194407
"Water full" cutout switch
depressed when spout for
continuous drainage is fitted.
EN