Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE
All parts of the stand mixer are to be thoroughly cleaned before being used for the
first time. (see section: Cleaning).
Take out the required length of cable from the cable tidy on the base of the
blender and connect the device to the mains supply.
Trial use
1.
Revolve the locking switch, then lift the machine arm.
2.
Put the mixing bowl onto the base, and lock it as the arrowhead denotes.
3.
Fix the dusty cover onto the mixing blade, then lock the blade into the
machine.
4.
Revolve the locking switch, then push the upper cover down and make the
arm down. Make sure the arm is fixed together the base, then Revolve the
locking switch up to lock the arm solidly.
5.
Plug-in the cord, and turn the switch slowly from speed"1" to speed "8" ( every
speed try for a few seconds).
6.
After the trial, turn the switch to speed "OFF".
7.
Turn the locking switch and lift the arm, then take apart the mixing blade from
the blade connector try again.
EN
23
Publicidad
