Descargar Imprimir esta página

Chamberlain 950ESTD Guia De Inicio Rapido página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

TO CONTROL THE GARAGE DOOR OPENER LIGHTS
This feature is only available on garage door openers equipped with a multi-function door control and a remote control with more than one button. Not available with external receiver.
A remote control button can be programmed to operate the garage door opener lights without opening the door.
With the door closed,
press and hold
the remote
control button
that you want to
control the light.
Test by pressing the remote control button. The garage door opener lights should turn on or off but the door should not move.
THE REMOTE CONTROL BATTERY
The lithium battery should produce power for up to 5 years. If the battery is low, the remote control's LED will
not flash when the button is pressed. To replace battery:
Pry open the case first
Remove the old battery.
in the middle (1), then
Dispose of old batteries
at each side (2 and 3)
properly.
with the visor clip.
3
1
2
HOW TO USE THE REMOTE CONTROL
Press and hold the button down until the door or gate
starts to move. The remote control will operate from
up to 3 car lengths away on typical installations.
Installations and conditions vary, contact an installing
dealer for more information.
REPLACEMENT PARTS
3V2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
Press and
hold the
+
LIGHT button
on the
door control.
Replace cover.
Insert replacement
batteries positive side up.
Replace the batteries
with only 3V2032
coin cell batteries.
3V2032
Press and
hold the
+
LOCK button
on the
door control.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.
NOTICE: This device complies with part 15 of the FCC rules and Innovation, Science and Economic
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
Development Canada licence-exempt RSSs. Operation is subject to the following two conditions: (1)
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery.
this device may not cause harmful interference, and (2) this device must accept any interference
THERE ARE NO OTHER USER SERVICEABLE PARTS.
received, including interference that may cause undesired operation. Any changes or modifications
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following
not expressly approved by the party responsible for compliance could void the user's authority to
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
operate the equipment. This device must be installed to ensure a distance of ≤5 mm is maintained
interference received, including interference that may cause undesired operation.
between users/bystanders and device.
3-BUTTON REMOTE CONTROLS
Additional buttons on the remote control can be
programmed to operate up to 3 devices such as
additional garage door openers, light controls, gate
operators or access control systems.
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is free
from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
After the garage
door opener
lights flash,
release all
buttons.

Publicidad

loading

Este manual también es adecuado para:

953estd