Publicidad
Idiomas disponibles
Idiomas disponibles
3. To check the chain tension, lightly pull the chain 1/8"
(3 mm) away from bottom of guide bar. If the chain snaps
back into place upon release, the tension is correct.
During normal operation, the chain will heat up and
expand causing the chain sag slightly by approximately
0.05 in. (~1.25 mm) (Fig. 13).
NOTE: A new chain will stretch. Check the tension of
a new chain frequently during the first two hours of
operation, after disconnecting the battery and allowing the
chain to cool down.
Fig. 13
Warm chain after use - properly tensioned
Warm chain after use - requires tensioning
4. Using the included wrench, turn the tensioning wheel
counter-clockwise to loosen the chain (Fig. 14).
Fig. 14
Tensioning
wheel
Chain Lubrication
m
WARNING!
Failure to lubricate the chain will cause
damage to the bar and chain. Only use a good quality bar and
chain oil designed specifically for use with chain saws. Do not
use oil containing impurities.
IMPORTANT! The bar and chain oil is bio-degradable. The
use of mineral oil or engine oil can have a serious impact on
the environment. It is essential that you use good quality oil to
lubricate the cutting parts effectively. Used or poor quality oil
does not guarantee good lubrication and reduces the lifespan
of the chain and bar.
0.05 in. (1.25 mm)
R
R
Too loose
Wrench
1. Take off the oil tank cap from the top of the pruning saw.
Then fill the oil tank up to top of the oil tank indicator
marked with the word "MAX" (Fig. 15).
Fig. 15
Bar and chain oil
Oil tank cap
2. During operation, press the compression cap 3-4 times
every 30 minutes to lubricate the chain (Fig. 16).
NOTE: Before storing the unit, press the compression cap
3-4 times and run the saw for 30 seconds to lubricate the
chain evenly to prevent corrosion.
Fig. 16
Compression cap
Breaking-in your Pruning Saw
It is recommended to break-in your pruning saw every time a
new chain is installed.
1. Remove the battery and adjust the chain tension.
2. Insert the battery and switch on the pruning saw and leave
the motor running idle for approximately 5 minutes.
3. Remove the battery and check the chain tension again. If
necessary, re-tighten the chain.
4. Afterwards make only easy cuts for approximately 30
minutes. Always ensure sufficient lubrication of the saw
chain! Only use the pruning saw for heavier cuts and
greater cutting depths after the break-in period.
12
Oil tank indicator
Publicidad
