Publicidad
Idiomas disponibles
Idiomas disponibles
1.
CAUTION Do not let the cooktop drop into place.
Make sure that the cooktop is supported along the
▶
edges when carefully placing it into the cutout.
Turn the cooktop over carefully making sure not to dam-
age the pressure regulator and gas line.
Place the cooktop carefully into the countertop
‒
cutout, pulling it towards the front of the cutout
Lower the rear of the cooktop so that is rests flat on
‒
the counter
.
Center the cooktop left and right in the cutout
‒
Insert the 2½" clamping screws into the threaded holes
2.
of the hold-down brackets, slide or rotate the brackets
so that the clamping screws will contact the underside
of the countertop.
Protect delicate countertops by placing a wooden
‒
disk underneath.
Hand-tighten the first screw and check the cooktop
‒
position, then secure the cooktop by tightening all
clamping screws
.
Tighten the screws to the cooktop
‒
Note: Do not use silicone to glue the cooktop to the
countertop surface.
4.4 Connection overview
Refer to this illustration for the location of the gas and
electric connection of the appliance.
Note: Your appliance is equipped for use with natural gas
on delivery. If you want to use your appliance with LP gas
refer to the section on LP gas conversion before continu-
.
ing with the installation. → Page 14
.
a Cooktop rough-in box
b Arrow on pressure regulator, shows the direction of
c Pressure regulator
d ½" female pipe threads
e Metal flex gas line
f Power cord (40"/1 m)
g 120 V receptacle
h Gas cut-off valve
.
i
j
4.5 Connecting the gas supply line
The appliance is shipped from the factory for use with nat-
ural gas. If you want to use propane gas it must be con-
verted. A qualified technician or installer must do the con-
version.
Note
Ensure the following requirements are met before you try
to connect the appliance to the gas supply:
¡ Before connecting the appliance, check whether the lo-
cal connection conditions such as gas type and gas
pressure match the appliance settings.
¡ Make sure the gas supply is turned off at the manual
shutoff valve before connecting the appliance.
¡ The gas connection must be in a location that permits
access to the manual shut-off valve and which, if appli-
cable, is visible after opening the door or drawers of the
cabinet.
¡ The metal flex gas line must not come into contact with
moving parts of the fitted unit (e.g. drawers) or be laid in
areas where it could become trapped or damaged.
¡ The metal flex gas line must not come into contact with
a cooktop, oven, dishwasher, refrigerator, washing ma-
chine, hot water pipe, radiator or any other appliance in-
stalled in the vicinity of the gas cooktop.
gas flow
Gas supply line connection fitting
Floor
Installation procedure en-us
11
Publicidad
