Champion Global Power Equipment 500559-EU Manual Del Operador página 23

500559-EU - 2800W RATED PORTAbLE GENERATOR
5d. When petrol stops flowing from the carburetor, replace
and tighten the carburetor drain bolt and be sure to
properly dispose of the drained petrol according to
local regulations or guidelines.
6. Option 2: Run Dry
6a. With the generator running, turn the fuel valve to the
"OFF" position and allow the generator to run until the
engine stops from complete fuel starvation. This may
take a few minutes.
6b. Turn engine switch to the "OFF" position and allow
generator to cool completely before continuing.
7. Remove the spark plug cap and spark plug and pour about
a tablespoon of oil into the cylinder.
8. Pull the recoil slowly to crank the engine to distribute the
oil and lubricate the cylinder.
9. Install the spark plug and spark plug cap.
10. Clean the generator according to
11. Store the generator in a cool, dry place out of direct
sunlight.
Long Term Storage (over 1 year)
For storage over 1 year, the petrol tank and carburetor must be
completely drained of petrol.
1. Follow steps 1-4 according to
1a. Turn engine switch to the "OFF" position and allow
generator to cool completely before continuing.
2. Use the drain bolt on the carburetor to empty any
excess petrol from the petrol tank and carburetor into an
appropriate container. Use a funnel (and appropriate hose if
necessary) under the carburetor drain bolt to avoid spillage.
3. When petrol stops flowing from the carburetor, replace and
tighten the carburetor drain bolt and be sure to properly
dispose of the drained petrol according to local regulations
or guidelines.
4. Turn the fuel valve to the "OFF" position.
5. Follow steps 8-11 according to
Cleaning the Generator.
Mid Term Storage.
Mid Term Storage.
Transportation
To prevent fuel spillage when transporting or during temporary
storage, the generating set should be secured upright in its
normal operating position, with the engine switch OFF. The fuel
valve lever should be turned OFF.
When transporting:
Do not overfill the tank. Do not operate the generating set
while it is on vehicle. Take the generating set off the vehicle
and use it in a well-ventilated place. Avoid a place exposed
to direct sunlight when putting the generating set on a
vehicle. If the generating set is left in an enclosed vehicle
for many hours, high temperature inside the vehicle could
cause fuel to vaporize resulting in a possible explosion.
Do not drive on a rough road for an extended period with
the generating set on board. If you must transport the
generating set on a rough road, drain the fuel from the
generating set beforehand.
Removing from Storage
If the generator has been improperly stored for a long period
of time with petrol in the petrol tank and/or carburetor, all
fuel must be drained and the carburetor must be thoroughly
cleaned. This process involves technically advanced tasks. For
assistance please call our Technical Support Team .
If the petrol tank and carburetor were properly emptied of all
petrol prior to the generator being stored, follow the below
steps when removing from storage.
1. Be sure the engine switch is in the "OFF" position.
2. Add petrol to the generator according to
3. Turn the fuel valve to the "ON" position.
4. After 5 minutes check the carburetor and air filter areas for
any leaking petrol. If any leaks are found, the carburetor
will need to be disassembled and cleaned or replaced. If
no petrol leaks are found, turn the fuel valve to the "OFF"
position.
5. Check engine oil level and add clean, fresh oil if needed.
See Oil Specifications
6. Check and clear air filter of any obstructions such as bugs
or cobwebs. If necessary, clean air filter according to
Cleaning the Air Filter.
7. Start the generator according to
23
STORAGE
WARNING
Add Fuel: Petrol.
for proper oil type.
Starting the Engine.
EN