1. What's on the display
2. Fitting the batteries
What's on the display
Your TRX 4000 includes one battery pack for each handset.
To remove the belt clip
It is easier to fit the batteries without the belt clip in place.
Pull the tab forward (away from the handset) to release the belt clip.
Then lift the belt clip off.
To fit the batteries
Do not remove the sleeve from the battery pack.
1.
Slide down the battery compartment cover.
2.
Insert the battery pack making certain that the arrow is showing and
pointing towards the top of the handset.
3.
Replace the cover.
To fit the belt clip
Slide the belt clip down into the slot until it clicks into place.
Important – read these Safety Warning before you charge the batteries
When placing the handset in the charger, use only the rechargeable battery pack supplied
with the TRX 4000.
Make sure the battery compartment cover is securely locked in place when you are charging
the batteries.
Dispose of used batteries safely and in a way that will not harm the environment - never try
to burn them or put them anywhere, they could get burnt or punctured.
Don't leave dead batteries in your handset. They might leak if you do.
Channel number (1 to 8)
Sub-channel number (0 to 38)
Battery change level.
When the bars reduce, the battery needs charging
Shown when you are transmitting the signal
Shown when you are receiving the signal
Dual watch-shown when you are monitoring two channels at once.
Shown when the unit is in VOX
(voice activated mode)
Shown when the unit is scanning all channels
Shown when the buttons are locked
Volume level
Insert your
fingernail behind
the tab.
Lift the belt
clip off.
16