M7 DG501 Manual De Instrucciones página 14

TO ADJUST THE GUARD (FIG. 2)
To adjust the guard, keep the guard lever
open, then rotate the guard to a suitable
position so that the guard is positioned where
it can provide maximum operator protection,
then close the lever to lock the guard in place.
NOTICE: Use only grinding wheels of the
specified size with the grinding guard. Use
only cut-off wheels of the specified size
with the cutting guard.
NOTICE: The guard is pre-adjusted to
the diameter of the gear-box collar at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw in the guard with a Phillips-head
screwdriver (not included).
WARNING:
!
If the guard cannot be tightened by adjusting
the screw, do not use the tool and take the
tool and the guard to a service center to
repair or replace the guard.
TO INSTALL/REMOVE THE
AUXILIARY HANDLE (FIG. 3)
FIG. 3
Emplacement
poignée auxiliaire
This angle grinder/cut-off tool is equipped
with an auxiliary handle. The handle can
be installed in any of three auxiliary-handle
sockets. For ease of operation, position the
auxiliary handle in the location that offers the
best control and guard protection.
14
ASSEMBLY
Auxiliary-
Handle
1. To install the auxiliary handle, remove the
battery pack, then thread the auxiliary
handle into the auxiliary-handle socket and
tighten the handle securely by turning it
clockwise.
2. To remove the auxiliary handle, remove
the battery pack, then loosen the
auxiliary handle by turning the handle
counterclockwise.
WARNING:
!
For safety and ease of operation, securely
tighten the auxiliary handle by turning the
handle clockwise before every use.
TO INSTALL/REMOVE THE
AIR-INLET FILTER (FIG. 4)
FIG. 4
Air-Inlet
Filter
Using the air-inlet filter will improve the
performance and extend the life of the tool.
1. Remove the battery pack.
2. To install the filter, snap the filter onto the
tool's foot.
3. To remove the filter, pry the filter away from
the notch with a finger.
4. To clean the filter, tap it against a hard
surface or blow it clean with compressed
air. Always wear safety goggles when
cleaning tools using compressed air.
WARNING:
!
Always wear safety goggles or safety glasses
with side shields during power tool operation.
If operation is dusty, also wear a dust mask.
Notch