Publicidad
Idiomas disponibles
Idiomas disponibles
Guide to the control panel
"1" - Power Indicator
"2" - Power button
"3" - Up button
"4" - Setting button
"5" - Down button
"6" - Low/High Heating Selector
"7" - Generator (ION) button
"8" - Timer indicator
1. Operation Guide
1.1 STARTING
1.1.1 Remove the heater from the package box carefully. It is recommended to keep the box for
seasonal storage.
1.1.2 Make sure the convector heater is on OFF position before switching on.
1.1.3 It is better not to use the same electric outlet with other high wattage electrical appliances
in order to avoid overloading your circuit.
1.1.4 The heater comes with a remote control which is powered by 3V lithium button cell.
1.1.5 If the remote control battery needs replacement, insert new 3v battery.
Upon initial use, it is possible the heater will produce an odor, which will quickly evaporate. This
is normal and there is no need for further attention. Please allow adequate air ventilation.
1.2 TURN ON
Plug in the unit - the power indicator lights up after a short beeping sound.
Press "on/off" and the room temperature will appear. The current room temperature is displayed
and the factory-default is in "ºC" (not "F")
1.3 TEMPERATURE CONTROL
Press "SET" and the "35ºC" default indication will blink. Then press "
add 1°C or reduce 1°C. The maximum setting temperature is 45°C while the minimum one is 5°C.
1.4 SETTING TIMER
Press "SET" once again to set timer, setting time is displayed while timer indicator flashes (The
timer Unit is hour). Press "
pressing "
"/"
" to add or reduce 1 hour in 0.5 second. The factory-set timer is 0 hour. When
indicator is blinking with the up and down arrow buttons you may choose the desired time within
0,5sec. Upon the activation, there will be a timer indicator on the display.
If the timer is set to zero 0 the timer will be deactivated.
The unit is turned off without beeping sound when timing is over.
All manuals and user guides at all-guides.com
"9" - LED number display
"10" - Temperature (°C) indicator
"11"- Heating Indicator
"12"- High Heat Indicator
"13" - Low Heat Indicator
"14" - Generator (ION) indicator
"15" - Power button
"/"
" to add or reduce 1 hour, the timer range is 0~24hour. Keep
5
" or "
" arrow buttons to
Publicidad
