HQ-Power VDL10MB Manual Del Usuario página 2

VDL10MB / VDL20(C)MB / VDL30(C)MB(G) / VDL50MB
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted
municipal waste; it should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling service. Respect the local
environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying this mirror ball! Read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions and General Guidelines
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Keep the device away from children and unauthorised users.
• This device is designed for professional use on stage, in discos, theatres, etc.
• Select a location where the device is protected against extreme heat, dust and moisture.
• 30 cm and 50 cm mirror balls should be fixed with an appropriate safety cable (VDLSC7 or
VDLSC8). All other models should be used with a safety net.
• Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons and are not covered by the
warranty.
• Only use the device for its intended purpose. All other uses may lead to a crash, injuring people
badly. Using the device in an unauthorised way will void the warranty.
3. Installation
• Have the device installed by a qualified person, respecting EN 60598-
2-17 and all other applicable norms.
• The construction to which the device is attached should be able to
support 10 times the weight of the device for one hour without
deformation. The installation area should be able to hold a minimum
point load of 30 kg.
• The installation must always be secured with a secondary attachment
e.g. a safety cable or safety net.
• Install the device in a location with few passers-by that is inaccessible
to unauthorised persons.
• Overhead mounting requires extensive experience: calculating
workload limits, determining the installation material to be used... Do
not attempt to install the device yourself if you lack these qualifications
as improper installation may result in injuries. Never stand directly
below the device when it is being mounted, removed or serviced. Have
a qualified technician check the device once a year and once before
you bring it into service.
• Have a qualified electrician carry out the electric connection.
VDL10MB / VDL20(C)MB / VDL30(C)MB(G) / VDL50MB_v2
MIRROR BALL
2
Velleman® nv