Safety Instructions - Tyrolit HCE150 Instrucciones De Funcionamiento Originales

HCE150
5

Safety Instructions

.
Safe work with the machine is only possible if you read this operating instruction completely and
follow the instructions contained strictly.
Additionally, the general safety instructions of the leaflet supplied with the tool must be observed.
Prior to the first use, the user should absolve a practical training. Save all warnings and
instructions for future reference.
.
If the mains cable gets damaged or cut during the use, do not touch it, but instantly pull the plug out of
the socket. Never use the tool with damaged mains cable.
.
The tool must neither be wet nor used in humid environment.
.
Do not use the tool in an environment with danger of explosion.
.
Do not work on ladders.
.
Do not drill into asbestos-containing materials.
.
Modifications of the tool are prohibited.
.
Never use the machine without dust guard.
.
Always check the tool, cable and plug before use. Have damages only repaired by specialists.
Insert the plug into the socket only when the tool switch is off.
.
When you work outside, the machine has to be used with a fault-current circuit breaker with max. 30 mA.
.
The machine should only work under supervision of somebody. Plug and switch the machine off if it is not
under supervision, in case of putting up and stripping down the machine, in case of voltage drop or when
fixing or mounting an accessory.
.
Switch the machine off if it stops for whatever reason. You avoid that it starts suddenly and not
under supervision.
.
Do not use the machine if a part of the housing is damaged or in case of damages on the switch, the
cable or plug.
.
Pay attention that the speed indicated on the cutting disc meets or is higher than the max. speed
indicated on the machine.
.
Use only diamond cutting wheels for your power tool.
.
Wheels must be used only for recommended applications. For example: do not grind with the side of the
cutting wheel.
.
Cutting wheels have to be stored and used carefully according to the instructions of the producer.
en 19