Publicidad
Enlaces rápidos
MEC MODULE SMART
EMOTION/EDC
Control unit for dual color led, 12/24Vdc, 1 out, Max 3A for out and 5A total.
433,92MHz radio receiver.
MEC MODULE SMART
Control unit for mono color led, 12/24Vdc, 1 out, Max 3A for out and 5A
total. 433,92MHz radio receiver.
c: 70°C
MEC MODULE SMART 1
1
1
MONO
ls-light.com
1
EN
Publicidad
Manuales relacionados para L&S MEC MODULE SMART 1 EMOTION/EDC
Resumen de contenidos para L&S MEC MODULE SMART 1 EMOTION/EDC
- Página 1 MEC MODULE SMART EMOTION/EDC Control unit for dual color led, 12/24Vdc, 1 out, Max 3A for out and 5A total. 433,92MHz radio receiver. ls-light.com MEC MODULE SMART MONO Control unit for mono color led, 12/24Vdc, 1 out, Max 3A for out and 5A total.
-
Página 2: Product Features
PRODUCT FEATURES DEFAULT SETTING SMART 1 EDC RECEIVER SMART 1 MONO RECEIVER - MEMO FUNCTION: The module Power supply 12 /24 Vdc 12 /24 Vdc always restores the last setting when LED with constant LED with constant switched on again (whether the module Type of load voltage dual color voltage... -
Página 3: Power Unit
Antenna Antenna - don’t cut - keep the cable untangled 74,9 - don’t attach the antenna on to metal surfaces - Double-sided adhesivefor wall mounting CONNECTION 95382 UTION ectric shock ion use only t c: 70°C Power Unit om | Made in China MEC MODULE SMART 1... - Página 4 SET UP (for use with remote control or sensor) This procedure lets you programme compatible controllers or sensors (transmitters). PROCEDURE: STEP 1 LED TURNS ON Press button 1. The LED turns on. PRESS BUTTON 1 SHORTLY STEP 2 Within 60 seconds press/touch the ON or other related button shortly on RED LED LIGHT FLASHES 3 TIMES your controller or sensor.
- Página 5 RESET MODULE/CONTROLLER This procedure lets you delete the programmed memory from the module and controllers (transmitters). PROCEDURE: STEP 1 LED FLASHES Press button 1 (about 5 seconds) until the LED begins to flash. PRESS BUTTON 1 (about 5 seconds) DELETION OF SINGLE TRANSMITTER DELETION OF ALL THE SAVED TRANSMITTERS STEP 2A STEP 2B...
-
Página 6: Advanced Settings
ADVANCED SETTINGS Default setting: no timer Use this procedure to reset the module back to factory settings. NOTE: Even stored transmitters (remote controls) will be deleted. PROCEDURE: STEP 1 Press hidden button ‘A’ with paper clip PRESS BUTTON ‘A’ SHORTLY shortly. - Página 7 RESET TIMER (MODULE) This procedure lets you reset the module back to factory settings. NOTE: even stored transmitters will be deleted. PROCEDURE: STEP 1 LED FLASHES Press button 1 (about 5 seconds) until the LED begins to flash. PRESS BUTTON (about 5 seconds) STEP 2 PRESS HIDDEN BUTTON ‘A’...
- Página 8 IMPORTANTE WARNING WICHTIG MPORTANT IMPORTANTE Conservare queste istruzioni. Le istruzioni Save these instructions.The instructions for Diese Anweisungen Aufbewahren. Die Conserver ces instructions. Ces consignes Conservar estas instrucciones. Debe seguir devono essere seguite in maniera use must be scrupulously complied with Montageanweisungen müssen gewissenhaft d’utilisation doivent être scrupuleusement escrupulosamente las instrucciones de uso...