IKEA PRAKTLYSING Manual De Uso página 7

Factory reset your devices
After resetting the signal repeater, you must pair
the remote to the signal repeater and then pair the
remote to the wireless blind again.
Signal repeater:
Push a pin into the pinhole on bottom of the signal
repeater for at least 5 seconds.
Remote:
Press the pairing button 4 times
within 5 seconds. A red LED light will
flash, indicating that it has been reset.
Wireless blind:
Press and hold both buttons for 5 seconds.
A white LED light will flash 4 times, indicating the
blind has been reset.
Good to know
• The power supply unit can be used to charge the
wireless blind's battery pack.
• USB cable length and quality influences the
charging speed and performance.
• Devices may become warm during charging. This
is completely normal and they will gradually cool
down again after they are fully charged.
• Unplug the power supply unit from the wall
socket before cleaning and when it is not in use.
• The battery pack should not be left discharged for
a longer period of time.
• The battery pack should not be charged while in
contact with flammable materials like textiles.
• This battery pack can only be used with IKEA
products.
IMPORTANT!
Wireless blind package:
• The included devices are for indoor use only and
can be used in temperatures ranging from 0ºC to
40ºC (32ºF to 104ºF).
• Storage temperature: -20°C to 25°C (4°F to 77°F).
• Do not leave any device in direct sunlight or near
any heat source, since it may overheat.
• The range between the transmitter and the
receiver is measured in open air.
• Different building materials and placement of the
units can affect the wireless connectivity range.
WARNING:
Power supply unit:
• The wall socket must be located near the
equipment and must be easily accessible.
• If any device is damaged, it should not be used
and should immediately be disposed of.
• Do not subject the units to wet, moist or
excessively dusty environments since this can
cause damage to the units.
• Never use a damaged or faulty USB cable for
charging, since this can damage the product and
harm your device.
Recommended precautionary measures and
technical data, see the back of the power supply
unit.
WARNING
Battery pack:
• Do not modify, disassemble, open, drop, crush,
puncture, or shred the battery.
• Do not expose the battery to rain or water.
• Risk of fires and burns. Do not subject the battery
to a temperature over 60°C and do not incinerate
the battery.
• Keep the battery away from open flames or
sunlight to prevent heat build-up.
• Keep the battery away from high voltage devices.
• This product is not a toy, keep away from children.
Ensure that all persons who use this product read
and follow these warnings and instructions.
• Do not short-circuit the battery or its cells.
• In the event of a battery cell leaking, do not allow
the liquid to come in contact with the skin or eyes.
7